Stand Up Paddling, Foil, SUP Foiling, Foil Surfing, Wing Surf, Wing Surfing, Wing Foiling. This is your forum!
s
I think you can start with the rear at zero, based on my conversation with a guy who's built a few. Is your front wing going under the fuselage? That's the most common setup. My foil is on hold because I might see a few in a few weeks in Hatteras and get some ideas, and my ice just went out and I won't be riding it (swimming a lot) any time soon! Hatteras is also too shallow in many spots. On lighter days I'll suppin the ocean side.Peter
Quote from: peterwSUPr on April 05, 2016, 07:53:11 PMI think you can start with the rear at zero, based on my conversation with a guy who's built a few. Is your front wing going under the fuselage? That's the most common setup. My foil is on hold because I might see a few in a few weeks in Hatteras and get some ideas, and my ice just went out and I won't be riding it (swimming a lot) any time soon! Hatteras is also too shallow in many spots. On lighter days I'll suppin the ocean side.PeterHello,just tried my DIM home foil today, amzing but lift is very brutal. understood rear wing/stabilizer is set to downward lift ( flat face/intrado up/extrado down) with angle abt 2° downwards, am I right? did someone tried rear wing with extrado up same as main wing ? in that/any case which angle? i can reverse rear wing or adjust angle with shims. thanks in advance.
Quote from: blueplanetsurf on June 05, 2017, 09:47:41 AMQuote from: supuk on May 30, 2017, 01:27:52 PMNew foil board is getting glasses but think I may keep it under raps till it's done. I have also been working on some install kits to make it a lot easier to install the double boxes into the board. The final ones will probably get made in P.E.TI think this is a great idea, are you planning to sell this?Yes I think I will cut a few and see if there is any interest. I have just got a few different types of HD foam to try to see what's going to work best and keep the cost as low as posable.
Quote from: supuk on May 30, 2017, 01:27:52 PMNew foil board is getting glasses but think I may keep it under raps till it's done. I have also been working on some install kits to make it a lot easier to install the double boxes into the board. The final ones will probably get made in P.E.TI think this is a great idea, are you planning to sell this?
New foil board is getting glasses but think I may keep it under raps till it's done. I have also been working on some install kits to make it a lot easier to install the double boxes into the board. The final ones will probably get made in P.E.T