Author Topic: Kalama E3 Sup/Wing - will it work with Axis PNG foils for winging?  (Read 1132 times)

Canadian_foiler

  • Waikiki Status
  • *
  • Posts: 5
    • View Profile
    • Email
Hi,

After doing some additional reading it sounds like the Kalama E3 Sup/Wing will work for Armstrong HA and HS foils but it made me wonder about Axis wings.  I have the 1010 and 1150 PNG and was wondering if these will work on this board. I will primarily be using it for winging.   Eventually I'm sure I would like to switch to their HPS line as well. 

It would be great to know if these will work before buying the board.  Looking to get this as my first wing board, I've been wake foiling for 3 years.

Thanks!

Hdip

  • Sunset Status
  • ****
  • Posts: 442
    • View Profile
Re: Kalama E3 Sup/Wing - will it work with Axis PNG foils for winging?
« Reply #1 on: January 13, 2023, 07:53:18 AM »
With the standard fuses yes. With the advanced fuses maybe. Tracks are kind of setup for Gofoil mainly. So systems that like to be mounted in the rear of the box work well with it.

flkiter

  • Sunset Status
  • ****
  • Posts: 315
    • View Profile
    • Email
Re: Kalama E3 Sup/Wing - will it work with Axis PNG foils for winging?
« Reply #2 on: January 13, 2023, 06:48:46 PM »
I had an E3 105 liter and it worked fine with the Axis foils. If you're using Armstrong or an advance fuselage then the tracks will be too far back for you to use the foot straps.

pafoil

  • Malibu Status
  • **
  • Posts: 68
    • View Profile
    • Email
Re: Kalama E3 Sup/Wing - will it work with Axis PNG foils for winging?
« Reply #3 on: January 15, 2023, 09:51:55 PM »
I had an E3 105 liter and it worked fine with the Axis foils. If you're using Armstrong or an advance fuselage then the tracks will be too far back for you to use the foot straps.

I use the E3 5.0  and Armstrong, I have no problems.

 


SimplePortal 2.3.7 © 2008-2023, SimplePortal