Author Topic: Gelcoat on Jimmy Lwis Repair  (Read 379 times)

toolate

  • Sunset Status
  • ****
  • Posts: 270
    • View Profile
Gelcoat on Jimmy Lwis Repair
« on: October 03, 2020, 04:14:33 PM »
I have a couple of small (about 1/2 CM dings where the white gelcoat (I think it is gelcoat) got removed. I can see intact carbon fiber layer underneath

What should i sue to hide these dings? They dont look structural of appear to leak...

But better safe than sorry.



PonoBill

  • Cortez Bank Status
  • *****
  • Posts: 23886
    • View Profile
Re: Gelcoat on Jimmy Lwis Repair
« Reply #1 on: October 03, 2020, 06:45:40 PM »
It's not gelcoat, probably just paint. suck on it to make sure you don't have any leaks. If you don't a little spot putty to take out the ridges, a bit of sanding, and then paint it.
Foote 10'4X34", SIC 17.5 V1 hollow and an EPS one in Hood River. Foote 9'0" x 31", L41 8'8", 18' Speedboard, etc. etc.

toolate

  • Sunset Status
  • ****
  • Posts: 270
    • View Profile
Re: Gelcoat on Jimmy Lwis Repair
« Reply #2 on: October 04, 2020, 06:31:31 PM »
thanks
What is spot putty?

surfcowboy

  • Cortez Bank Status
  • *****
  • Posts: 4213
    • View Profile
Re: Gelcoat on Jimmy Lwis Repair
« Reply #3 on: October 04, 2020, 07:00:57 PM »
Itís made and sold by Google. Go to their site and type it in.

Sorry, I had to. ;)

 


SimplePortal 2.3.7 © 2008-2020, SimplePortal