NSI stick on foot inserts

[supfoo]

Ok, so we've gone over how to put theses on. What's the best way to remove?

[PonoBill]

Warm them up a little, not too much, soak the area with alcohol and use a putty knife, Take your time. It takes a lot of force. The alcohol is just there to prevent it from sticking down again. VHB is a bitch to get off, especially the version NSI uses.

[Sam the Surfer]

I’ve had a very good experience with these stick ons. Be sure to get all the paint off the board and sand. Clean and stick!