Author Topic: NSI stick on foot inserts  (Read 14943 times)

supfoo

  • Rincon Status
  • ***
  • Posts: 139
    • View Profile
NSI stick on foot inserts
« on: October 27, 2019, 06:27:15 PM »
Ok, so we've gone over how to put theses on. What's the best way to remove?

PonoBill

  • Cortez Bank Status
  • *****
  • Posts: 25864
    • View Profile
Re: NSI stick on foot inserts
« Reply #1 on: October 27, 2019, 06:31:06 PM »
Warm them up a little, not too much, soak the area with alcohol and use a putty knife, Take your time. It takes a lot of force. The alcohol is just there to prevent it from sticking down again. VHB is a bitch to get off, especially the version NSI uses.
Foote 10'4X34", SIC 17.5 V1 hollow and an EPS one in Hood River. Foote 9'0" x 31", L41 8'8", 18' Speedboard, etc. etc.

Sam the Surfer

  • Rincon Status
  • ***
  • Posts: 185
    • View Profile
    • Email
Re: NSI stick on foot inserts
« Reply #2 on: November 04, 2019, 05:15:20 PM »
I’ve had a very good experience with these stick ons. Be sure to get all the paint off the board and sand. Clean and stick!

 


SimplePortal 2.3.7 © 2008-2024, SimplePortal