Author Topic: Foil Share File Share  (Read 785 times)


  • Administrator
  • Cortez Bank Status
  • *****
  • Posts: 4136
    • View Profile
    • StandUpZone
    • Email
Foil Share File Share
« on: December 08, 2018, 09:46:40 AM »
Hi guys,

There has been some expressed interest in sharing some files for 3D printing and other shaping technologies.  Feel free to use this thread to share files and post details about those files.  Have fun!

PS:  I have enabled an initial group of file extensions for upload.  If you are getting errors on your files or need additional file types please let me know.
« Last Edit: December 08, 2018, 09:48:40 AM by Admin »


  • Sunset Status
  • ****
  • Posts: 437
    • View Profile
    • Email
Re: Foil Share File Share
« Reply #1 on: December 09, 2018, 06:35:09 AM »
Here is a set of 4" side fins (flat insides) fins I did using a open-source software chain for the design.

They were featured in a tweet from finFoil showing multiple technologies to make the same fin. The tweet has a short URL lthat is a link to my process and a discussion of the foiling software.

Thanks to Admin for allowing us to attach design-type files on the 'Zone!

« Last Edit: December 09, 2018, 06:42:38 AM by jrandy »
Be safe, have fun. -J


  • Malibu Status
  • **
  • Posts: 50
    • View Profile
Re: Foil Share File Share
« Reply #2 on: February 08, 2019, 10:59:41 PM »
Not technically a 3d file but thought it would be a handy place to leave this.

Feel free to add to it.