Standup Zone Forum
The Foil Zone => Foil SUP => Topic started by: supfoo on October 27, 2019, 06:27:15 PM
-
Ok, so we've gone over how to put theses on. What's the best way to remove?
-
Warm them up a little, not too much, soak the area with alcohol and use a putty knife, Take your time. It takes a lot of force. The alcohol is just there to prevent it from sticking down again. VHB is a bitch to get off, especially the version NSI uses.
-
I’ve had a very good experience with these stick ons. Be sure to get all the paint off the board and sand. Clean and stick!