Author Topic: Rail Tape  (Read 27793 times)

Johnny Mac

  • Waikiki Status
  • *
  • Posts: 38
    • View Profile
    • Email
Rail Tape
« on: September 29, 2010, 11:57:15 AM »
Does anyone have any experience with the rail tape offered by Surfco Hawaii?  I am very new to SUP's and I have already had to have my board repaired because of the chip I took out of it.  I am considering rail tape as well as nose and tail guards.  I don't really want to look like the pocket protector kind of guy out there but I don't want to damage my boards anymore. 

After my skill level increases does this stuff come off easily or will I be stuck with the clear guards on there? Any advice helps

Thanks


Spleen

  • Waikiki Status
  • *
  • Posts: 42
    • View Profile
Re: Rail Tape
« Reply #1 on: September 29, 2010, 12:39:38 PM »
They sure help but $40 for tape is ridiculous!!!  Go with the Clear 3M Scotch plastic vinyl tape ($3 a roll)...they're thinner but works and very discreet.....don't notice them only up close.

ehrawn

  • Rincon Status
  • ***
  • Posts: 152
    • View Profile
Re: Rail Tape
« Reply #2 on: September 29, 2010, 12:55:10 PM »
Skip the rail tape. It not only looks awful, it only protects your board where it's been applied. Since your paddle is the most likely source of the dings, put something on the edges. Many people use a little padding and electrical tape. I went with the Surfco paddle guard: it works, is descrete, doesn't mark my board as easily as waterloged electrical tape and, after a year+ of use, it still looks as clean as the day I put it on.

Johnny Mac

  • Waikiki Status
  • *
  • Posts: 38
    • View Profile
    • Email
Re: Rail Tape
« Reply #3 on: September 29, 2010, 12:55:26 PM »
I was thinking the same thing concerning price.  I understand the formed and shaped nose and tail guards being about $35.00 but a strip of clear tape 3"x72" is a bit over priced at $40.00.  I will check around for the 3M tape.  Thanks

Johnny Mac

  • Waikiki Status
  • *
  • Posts: 38
    • View Profile
    • Email
Re: Rail Tape
« Reply #4 on: September 29, 2010, 12:59:01 PM »
I have just put the paddle guard on.  I didn't know if that would be sufficient or if I should add some tape to the board.  Thanks

SoCalSupper

  • Cortez Bank Status
  • *****
  • Posts: 3347
  • support the HPWA!
    • View Profile
    • HPWA
Re: Rail Tape
« Reply #5 on: September 29, 2010, 02:27:06 PM »
paddle guard is the way to go. Rail tape looks lame and it comes off easily
United States Air Force Para-Rescue motto "That others may live"

redfour

  • Waikiki Status
  • *
  • Posts: 32
    • View Profile
Re: Rail Tape
« Reply #6 on: September 29, 2010, 02:48:05 PM »
I made the daft mistake of applying rail tape to my Starboard Blend. Use a good paddle guard tape instead.
It took me hours to carefully remove rail tape when it showed signs of failing (after 6 months) and I still managed to take most of the board's top coat off in the process.

dalidali

  • Malibu Status
  • **
  • Posts: 54
    • View Profile
    • KayakSport.net
    • Email
Re: Rail Tape
« Reply #7 on: September 29, 2010, 03:18:44 PM »
I use 3M helicopter tape. Lasts forever. M

mik911

  • Peahi Status
  • *****
  • Posts: 799
    • View Profile
Re: Rail Tape
« Reply #8 on: September 29, 2010, 08:07:32 PM »
I use 3M helicopter tape. Lasts forever. M
What is Helicopter tape, and where do you get it?

I was also wondering about the nose guard.  I have them on my surfboards, and they work great.  The tail guard is kinda a waste, and was so small on my surfboard that it came off.
It's the nose of the board that takes all of the pounding, not the tail.

« Last Edit: September 29, 2010, 08:12:35 PM by mik911 »
Mike

Ron House Coastal Cruiser 12'6"
Hoe Nalu surf sup  10'6"
BARK 14' custom carbon SUP
Fanatic Fly Race 12'6" carbon SUP
BARK 14' prone custom paddleboard
BARK 12' prone Surftech paddleboard
Longboards: Harbour, Becker, Local Motion
Kneeboards: Cleary 5'10"
Handboard: Brownfish

mik911

  • Peahi Status
  • *****
  • Posts: 799
    • View Profile
Re: Rail Tape
« Reply #9 on: September 29, 2010, 08:08:28 PM »
  I don't really want to look like the pocket protector kind of guy out there but I don't want to damage my boards anymore. 

LOL
Mike

Ron House Coastal Cruiser 12'6"
Hoe Nalu surf sup  10'6"
BARK 14' custom carbon SUP
Fanatic Fly Race 12'6" carbon SUP
BARK 14' prone custom paddleboard
BARK 12' prone Surftech paddleboard
Longboards: Harbour, Becker, Local Motion
Kneeboards: Cleary 5'10"
Handboard: Brownfish

JL USA

  • Waikiki Status
  • *
  • Posts: 45
    • View Profile
    • Email
Re: Rail Tape
« Reply #10 on: September 29, 2010, 09:00:32 PM »
Rail Saver by Puka Patch is the best thing I've seen so far.
It's super thin, clear, UV resistant, doesn't peel, doesn't yellow.  visually and hydro-dynamically undetectable. 

I hate paddle guards because they cause the blade to vibrate through the water.


Marc996

  • Rincon Status
  • ***
  • Posts: 114
    • ICQ Messenger - 61565027
    • Yahoo Instant Messenger - marc_sps
    • View Profile
Re: Rail Tape
« Reply #11 on: September 30, 2010, 06:50:14 AM »
never mind the tape, those chicks look hot ;D

DavidJohn

  • Cortez Bank Status
  • *****
  • Posts: 6675
    • View Profile
    • Email
Re: Rail Tape
« Reply #12 on: September 30, 2010, 07:15:39 AM »
never mind the tape, those chicks look hot ;D

I agree.. Just what is holding that board up..  ;D

DJ

DavidJohn

  • Cortez Bank Status
  • *****
  • Posts: 6675
    • View Profile
    • Email
Re: Rail Tape
« Reply #13 on: September 30, 2010, 07:21:05 AM »
I agree on the paddle guard effecting the paddle and I'm not a big fan of rail tape.. This is all you need.. http://www.standupzone.com/forum/index.php?topic=4084.0

And stop hitting those rails..  ;D .. Often a good small blade light weight paddle will help if you're  rail whacker.

DJ

Johnny Mac

  • Waikiki Status
  • *
  • Posts: 38
    • View Profile
    • Email
Re: Rail Tape
« Reply #14 on: September 30, 2010, 07:43:32 AM »
Yeah I was hoping to not continue whacking away at the rails.  That is kind of why I was looking for some insight on removal.  I don't want my boards to look like rentals. 

I think JL USA posted a pic of rail guards?? I didn't even notice there was a board in the shot.

 


SimplePortal 2.3.7 © 2008-2024, SimplePortal