Speed Coach attachment question

[Esteroali]

So Santa left me this Speed Coach for Christmas. I bought it used and it came with the big suction cup attachment. Used it today for the first time and other than being heavy it seemed to work fine. I had the lanyard strung through a deck fitting for safety. Any thoughts on best attachment method?
Also for what it's worth I am also a rower. I have a SpeedCoach with an impeller for my rowing shell. I was told by NK the. "Algorithms" for the rowing and SUP Speed Coaches were different. I used the SUP SpeedCoach on my rowing shell and it matched the older impeller unit perfectly. Go figure.

[juandoe]

http://www.nkhome.com/rowing-sports-products/nk-rowing-sports/accessories/adjustable-surface-mount

The new mount is gopro mount compatible.  The attachment plastic is so cheap mine broke before its first use.  I switched out to a real gopro mount and it works great.  The other problem was they sent a curved attachment that didn't fit my board.  I used a flat gopro one.

[Esteroali]

So should I use the NK mount or Go pro? I'm confused. Since my mount is stuck to this orange suction cup thing what pieces and from whom would I need to get?

[Kieranrsup]

I use a large GoPro surf mount stuck to the deck pad of my 17'4" Bullet.
I use the deck leash plug for the Speed Coach leash.
On my Starboard Ace & Sprint, Starboard were kind enough to include FCS plugs up front of the standing area which I use there, again with GoPro mounts.

[Esteroali]

Is this what I want to order?

[Glowmaster]

My Speedcoach is the last generation and has a simple 45% mount with a hole for a 1/4 -20.

My board maker put in an insert for 1/4 -20 up front on the deck.

I use the lanyard to another leash insert up there.

I leave the mount on the deck all the time and slide on the Speedcoach before a session.

Very convenient, but not angle adjustable.

ed

[juandoe]

So should I use the NK mount or Go pro? I'm confused. Since my mount is stuck to this orange suction cup thing what pieces and from whom would I need to get?

Is the mount attached to the suction mount via a thumbscrew?  If so, you can buy one of the go pro mounts and replace it.  These parts would work
http://shop.gopro.com/mounts/replacement-parts/AGBAG-001.html#/prefn1=gp_itemType&prefv1=Mounts&start=1

You would only need the receiver part (the part that sticks to the board) and the removable mount part (the part that engages the receiver) but I cant remember seeing them individually.